Dimmer Module

Dimming Module Interface

• Reset this key is to used to reset the dimming module interface when it’s abnormal
• Signal OK LED: the LED flashes indicate that the signal receiving is normal
• Sys OK LED: the LED flashes indicate that the dimming system controller is normal
• Panic On LED: the LED is on means that it is in panic mode, off means normal
• Circuit O/P LED: these LEDs correspond to each channel, when the channel has output,
• the corresponding LED will on, and its level indicate the level of the load
• Power LED: Power LED has 3 (A/B/C) LEDs, each LED represent one phase.
• In normal condition, all the 3 LEDs are all on, and their levels are the same.

• For incandescent, low voltage halogen, neon & fluorescent.
• For inductive loads ON/OFF switching purposes.
• For ON/OFF switching purposes.
• For fluorescent loads.